TEP-1560-BSW HARDWARE MANUAL
– VER 1.00 MAR 25 2019
Page
22
of
39
4.3. RTC Battery Connector
The TEP-1560-BSW features an internal RTC backup battery connector (Marked F).
Pin #
Signal
Description
1
RTC_VCC
3V (connect to standard CR2032 battery)
2
GND
Ground
Header on TEP-1560-BSW: Molex 53047-0210 (1.25mm Pitch PicoBlade Wire-to-Board Header).
Cable receptacle: Molex 051021-8602 (1.25mm Pitch PicoBlade Wire-to-Wire and Wire-to-Board Housing)
plug with crimp contact Molex 50058-8000.
Battery P/N: KTS BCR2032H14.0AM1XB.
4.4. M.2 KEY-E Slot
The TEP-1560-BSW has one internal M.2 KEY-E connector: WIFI/BT (Marked G). M.2 WIFI/BT connector
supports PCIe and USB 2.0 signals. Only M.2 cards in the industry-standard M.2 KEY-E 2230 (22 x 30
mm) form factor are supported.
NOTE: M.2 WIFI/BT connector can be only used by a M.2 KEY-E Wi-Fi / Bluetooth module installed into
the M.2 KEY-E connector (Marked G).
4.5. CMOS Jumper
To clear CMOS settings please turn the system off and disconnect the RTC battery (Marked D).
Pin #
Description
1-2
Default CMOS jumper settings
2-3
Clear CMOS jumper settings
Then short Pin #2 and Pin #3 of the 3-pin JCMOS1 header (Marked F) for 60 seconds, after which the
CMOS will be restored to default factory settings. Restore default CMOS jumper settings before turning
on the power. Reconnect the RTC battery (Marked D).
4.6. SO-DIMM DDR3L Slot
The TEP-1560-BSW has one SO-DIMM DDR3L memory slot (Marked H).