TEP-1560-BSW HARDWARE MANUAL
– VER 1.00 MAR 25 2019
Page
21
of
39
4. Internal Connectors and Expansion Options
Rear view (opened device):
I
J
Power
I/O Expansion
Module
A
H
Module
B
C D
E F G
Internal Connectors and Switches:
No.
Description
No.
Description
A
M.2 KEY-B slot (SATA + USB 2.0)
F
RTC Battery connector
B
M.2 KEY-B slot (USB 2.0)
G
M.2 KEY-E slot (PCIe + USB 2.0)
C
SATA Power connector
H
SO-DIMM DDR3L slot
D
CMOS jumper
I
Internal R speaker connector
E
SATA 3.0 connector
J
Internal L speaker connector
4.1. M.2 KEY-B Slots
The TEP-1560-BSW has two internal M.2 KEY-B connectors: 3G/LTE and SATA (Marked B and A
respectively). M.2 3G/LTE connector supports USB 2.0 signals only. M.2 3G/LTE cards in the industry-
standard M.2 KEY-B 3042 (30 x 42 mm) or M.2 KEY-B 2242 (22 x 42 mm) form factor are supported. On
the other hand, M.2 SATA connector supports SATA and USB 2,0 signals. Only M.2 SATA cards in the
industry-standard M.2 KEY-B 2242 (22 x 42 mm) or M.2 KEY-B 2280 (22 x 80 mm) form factor are
supported.
NOTE: M.2 3G/LTE connector can be only used by a M.2 KEY-B 3G/LTE module installed into the M.2
connector (Marked B). No M.2 KEY-B 3G/LTE module is included in this device (must be purchased
separately, not sold by TechNexion).
4.2. SATA 3.0 and SATA Power Connectors
The TEP-1560-BSW has one internal SATA 3.0 connector (Marked C) for connecting to a SATA storage
device. SATA Power connector (Marked B) is located next to it.
NOTE:
There is one 2.5” internal disk drive bracket available.
