16
USB Extender Mounting
The bottom of the TL-FO-USB3-01 enclosures features four pre-drilled holes for optional surface mounting.
To ensure the stencil below prints to scale be sure to set the page scaling setting to “none”.
Distance between the enclosure mounting holes: 42.0 mm x 77.0 mm
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or using
a print out of the stencil below.
2. Hardware recommendation: M3.0 locking washers and M3.0 screws (4 of each per extender) noting screw
length will depend upon thickness of mounting surface.
3. Drill through each of the four hole markings on the mounting surface using a 4.7625mm (3/16”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
mounting hole
42 mm
(1.65 in)
4.76 mm
(0.1875 in)
77 mm
(3.03 in)
