Page 7
Nearby metal surfaces may cause a decrease in reading distance and speed. This is caused
by the combined effects of parasitic capacitance and conductance.
4.4 Mounting and removal of the terminal
The mounting suppose using a round or square installation box
(
Pic. 3
). Open the unit using a screwdriver in the slot (1). After
mounting the installation box into a wall, fasten the rear part of
the terminal to it using screws (2a, 2b). It is appropriate to create
a coil with the cables C1 and C2 enwinding them through the
supplied ferrite circlet (3). The cables must be led through the
slot in the rear part of the terminal and plugged in the front part
of the terminal (4). Set the front part of the terminal on the upper
edge of the mounted part and rotate it until the part snaps down
(5).
Pic. 3: Terminal mounting
2 a)
2 b)
3)
4)
1)
5)
