1.0
Installation Instructions for
Vance and Lance 13 Flush Mount
700FMVNC13, 700FMLNC13
920FMVANLANS
CAUTION RISK OF FIRE
-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
CEILING COLLECTION
G
P
I
:
ENERAL RODUCT NFORMATION
These fixtures are intended to be installed
utilizing
compliant junction boxes.
NEC
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
1A
Ground the fixture in accordance with local electrical
codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
1
2
3
2
1
3
Install the fixture
Align the through holes in the fixture base with the #8-
32 screws to junction box.
Firmly tighten the #8-32 screws to hold the fixture base
in place through the next steps.
4
3
5
1B
1B
2
4
5
Note
: depending on the dimensions of the J-box, you
may use either the inner or outer through holes.
1
FIXTURE
BASE
#8-32
SCREW
5
FIXTURE
BASE