Installation Instructions for
920E3
-
LED AE
Round or Square Chicago Plenum Adjustable Housing
with
Lamp
Emergency Battery Backup and LED
E3_-L_AE
1.4
1
LED ROUND SQUARE
-
/
Install the Housing with Adjustable Bars
1A
BREAK OFF
AND DISCARD
¾” or thicker
½” to ¾”
LEAVE TAB
IN PLACE
Keep Tab for ceiling ½” to ¾” thick.
When using adjustable hanger bars with ½” to ¾” thick
ceilings, leave the tab of the hanger bars in place.
Break off Tab for ceiling ¾” or thicker.
When using adjustable hanger bars with ¾” or thicker
ceilings, remove the tab by bending it at the perforation.
1
NOTE:
Skip this section if installing the housing
with butterfly brackets.
HOUSING CLASP
HOUSING
1B
INNER ADJUSTABLE BAR
OUTER ADJUSTABLE BAR
TAB
STOP POINT
3
3
NAIL
2
2
3
4
Slide the inner adjustable bar completely through the
three housing clasps. Make sure the nail is on top.
Slide and push the outer adjustable bar completely onto
the inner adjustable bar so that the tab clicks into place
behind the stop point. This will prevent the adjustable bars
from coming apart.
Repeat steps 2 & 3 for the other side of the housing.
G
P
I
:
ENERAL RODUCT NFORMATION
This product is suitable for indoor locations.
This product can be dimmed with a standard electronic dimmer.
This instruction shows a typical installation.
CAUTION RISK OF FIRE
-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the
hazards involved.
Use minimum 90°c supply conductors.
1C
COLLAR
NAIL
JOIST
NAIL
5
5
6
6
NOTE:
The adjustable bars can be mounted to
joists that are spaced 16" - 24" apart.
Align the bottom of the end plates with the bottom of the
ceiling joists.
Level the adjustable bars and, with a hammer, tap the nails
completely into the joists to secure the adjustable bars in
place.
5
6
5
6
