Tech Controllers EU-294v1 User Manual Download Page 1

Page: 1 / 2

USER’S MANUAL

EU-294 v1,

Safety

Before using the device for the first time the user should read the

following regulations carefully. Not obeying the rules included in this

manual may lead to personal injuries or controller damage. The user’s

manual should be stored in a safe place for further reference. In order to

avoid accidents and errors it should be ensured that every person using

the device has familiarized themselves with the principle of operation as

well as security functions of the controller. If the device is to be sold or

put in a different place, make sure that the user’s manual is there with

the device so that any potential user has access to essential information

about the device.

The manufacturer does not accept responsibility for any injuries or

damage resulting from negligence; therefore, users are obliged to take

the necessary safety measures listed in this manual to protect their lives

and property.

WARRANTY CARD

TECH company ensures to the Buyer proper operation of the device for the period of 24 months from the date of sale. The Guarantor

undertakes to repair the device free of charge if the defects occurred through the manufacturer’s fault. The device should be delivered to its manufacturer.

Principles of conduct in the case of a complaint are determined by the Act on specific terms and conditions of consumer sale and amendments of the Civil

Code (Journal of Laws of 5 September 2002).

CAUTION! THE TEMPERATURE SENSOR CANNOT BE IMMERSED IN ANY LIQUID (OIL ETC). THIS MAY RESULT IN DAMAGING THE CONTROLLER

AND LOSS OF WARRANTY! THE ACCEPTABLE RELATIVE HUMIDITY OF THE CONTROLLER’S ENVIRONMENT IS 5÷85% REL.H. WITHOUT THE STEAM

CONDENSATION EFFECT. THE DEVICE IS NOT INTENDED TO BE OPERATED BY CHILDREN.

Activities related to setting and regulation of the controller parameters described in the Instruction Manual and parts wearing out during

normal operation, such as fuses, are not covered by warranty repairs. The warranty does not cover damages arising as a result of improper operation

or through the user’s fault, mechanical damage or damage created as a result of fire, flood, atmospheric discharges, overvoltage or short-circuit.

The interference of an unauthorized service, wilful repairs, modifications and construction changes cause the loss of Warranty. TECH controllers have

protective seals. Removing a seal results in the loss of Warranty.

The costs of unjustifiable service call to a defect will be borne exclusively by the buyer. The unjustifiable service call is defined as a call to

remove damages not resulting from the Guarantor’s fault as well as a call considered unjustifiable by the service after diagnosing the device (e.g. damage

of the equipment through the fault of the client or not subject to Warranty), or if the device defect occurred for reasons lying beyond the device.

In order to execute the rights arising from this Warranty, the user is obliged, at his own cost and risk, deliver the device to the Guarantor

along with a correctly filled-in warranty card (containing in particular the sale date, the seller’s signature and a description of the defect) and sales proof

(receipt, VAT invoice, etc.). The Warranty Card is the only basis for repair free of charge. The complaint repair time is 14 days.

When the Warranty Card is lost or damaged, the manufacturer does not issue a duplicate.

...................................... ......................................

seller’s stamp date of sale

WARNING

•

High voltage! Make sure the regulator is disconnected from

the mains before performing any activities involving the

power supply (plugging cables, installing the device etc.)

•

The device should be installed by a qualified electrician.

•

Before starting the controller, the user shoud measure

earthing resistance of the electric motors as well as the

insulation resistance of the cables.

•

The regulator should not be operated by children.

WARNING

•

The device may be damaged if struck by a lightning. Make

sure the plug is disconnected from the power supply during

storm.

•

Any use other than specified by the manufacturer is forbidden.

•

Before and during the heating season, the controller should

be checked for condition of its cables. The user should also

check if the controller is properly mounted and clean it if dusty

or dirty.

We are committed to protecting the environment.

Manufacturing electronic devices imposes an

obligation of providing for environmentally safe

disposal of used electronic components and devices.

Hence, we have been entered into a register kept

by the Inspection For Environmental Protection. The

crossed-out bin symbol on a product means that the

product may not be disposed of to household waste

containers. Recycling of wastes helps to protect the

environment. The user is obliged to transfer their

used equipment to a collection point where all electric

and electronic components will be recycled.

EU Declaration of conformity

Hereby, we declare under our sole responsibility that

EU-294 v1

manufactured by TECH STEROWNIKI, head-quartered in Wieprz Biała

Droga 31, 34-122 Wieprz, is compliant with Directive 2014/35/EU of

the European Parliament and of the Council of 26 February 2014 on the

harmonisation of the laws of Member States relating to the making available

on the market of electrical equipment designed for use within certain

voltage limits (EU OJ L 96, of 29.03.2014, p. 357), Directive 2014/30/EU

of the European Parliament and of the Council of 26 February 2014 on the

harmonisation of the laws of Member States relating to electromagnetic

compatibility (EU OJ L 96 of 29.03.2014, p.79), Directive 2009/125/EC

establishing a framework for the setting of ecodesign requirements for

energy-related products as well as the regulation by the MINISTRY OF

ENTREPRENEURSHIP AND TECHNOLOGY of 24 June 2019 amending the

regulation concerning the essential requirements as regards the restriction

of the use of certain hazardous substances in electrical and electronic

equipment, implementing provisions of Directive (EU) 2017/2102 of the

European Parliament and of the Council of 15 November 2017 amending

Directive 2011/65/EU on the restriction of the use of certain hazardous

substances in electrical and electronic equipment (OJ L 305, 21.11.2017,

p. 8).

For compliance assessment, harmonized standards were used:

PN-EN IEC 60730-2-9:2019-06, PN-EN 60730-1:2016-10.

Wieprz, 08.04.2020

EU Declaration of conformity

Hereby, we declare under our sole responsibility that

EU-294 v2

manufactured by TECH STEROWNIKI, head-quartered in Wieprz Biała

Droga 31, 34-122 Wieprz, is compliant with Directive 2014/53/EU

of the European parliament and of the Council of 16 April 2014 on the

harmonisation of the laws of the Member States relating to the making

available on the market of radio equipment, Directive 2009/125/EC