6. LSServer, Scanner Shell and Download
6-98
Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5
2004-11
The End Remove Transport Lock window
In the
End Remove Transport Lock
window the static text informs the user that
transport lock has been successfully removed and that the instrument is ready for
use.
The
End Remove Transport Lock
window:
Click
Finish
to complete the
Remove
Transport Lock
procedure and close
Transport Unlock
wizard.
The Gain Calibration Wizard
The
Gain Calibration
is needed
to
take into account the differences in sensitivity
between PMTs used in
Tecan LS SERIES SCANNER
instrument. For each PMT
found in instrument the
Gain Calibration
must be done.
Tools needed for gain calibration are delivered with each instrument:
•
Scattered light glass slide
•
Calibration filter slide with different OD filters
•
Normal filter slide
Pay attention when loading the filter slides:
•
Gain Calibration PMT 1: Put the calibration filter slide in filter slot 1 and the
normal filter slide in filter slot 2.
•
Gain Calibration PMT 2: Put the calibration filter slide in filter slot 2 and the
normal filter slide in filter slot 1.
Note
To prevent damage to a PMT which has not been calibrated, a normal filter
slide must be loaded in the corresponding filter slot.
The
Gain Calibration
wizard is designed to quickly guide the user through the
gain calibration procedure. The following dialog boxes appear in succession:
The
Start Gain Calibration
window asks the user to put
special slide(s) into the instrument.
The
Prepare Gain Calibration
window prepares the
instrument for performing the gain calibration.
The
Measurement Gain Calibration
window carries out
the gain calibration.
The
Start Gain Calibration
window, the
Prepare Gain
Calibration
window and the Measurement
Gain Calibration
window are
repeated during gain calibration depending on the number of PMTs
available in instrument.
The
End Gain Calibration
window saves the gain
calibration data and finishes the gain calibration.
