Sayfa
4
/
22
●
CLEAN THE FIRE POT EVERYDAY.
●
THE FLAME TRANSMISSION PIPES MUST BE CLEANED IN 3-4 DAY PERIODS WITH
THE BRUSH SUPPLIED WITH YOUR STOVE OR BOILER.
●
AT THE END OF THE WINTER, GENERAL MAINTENANCE AND CLEANING (WITH
THE BRUSH) MUST BE CARIED OUT AND THE FUEL STORAGE MUST BE EMPTIED.
●
DAMAGES CAUSED BY USING INAPPROPRIATE PELLET AND NON-REGULAR
CLEANING ARE NOT COVERED BY WARRANTY.
●
THE FROST PROTECTION OF THE PUMPS WORKS WHEN THE HEATING WATER
DROPS BELOW + 5° C, AND TO PREVENT BLOCKING FROM CORROSION AND
SEDIMENT, THE SYSTEM AUTOMATICALLY OPERATES THE PUMP FOR 3-10 SECONDS
EVERY 24 HOURS. THEREFORE, DO NOT UNPLUG THE PRODUCTS DURING THE
WHOLE YEAR.
4. INSTALLATION AND CONNECTION
4.1 GENERAL INFORMATION
All the inspections for the pellet stove are done according to the stipulated standards. It
complies with the prescribed parameters related to combustion efficiency and flue gas
emissions. The product mentioned in this manual has been tested by the approved
bodies according to EN 14785 Standard.
The packaging of the stove protects the product from damage in the best possible way.
However, the stove or its accessories may still be damaged during transport. Therefore,
after removing the stove from the package, check whether it is complete and
undamaged. In case of any damage, notify your dealer.
4.2 SAFETY
* Product must be installed by an authorized person.
* Before installing the product, it should be determined whether the bearing capacity of
the floor to be installed is durable to the product. In case of insufficient bearing
capacity, appropriate measures should be taken. If the floor where the stove is to be
installed is flammable or heat-sensitive, you should place a base (eg marble or glass
base).
* Care must be taken to ensure that the ventitlation conditions of the place where the
product is installed and frost protection measures are taken (such as antifreeze)
