Team SILK AX14-60, Instruction Manual

Page: 44 / 92

AX14-60 Flange Facing Machine
43
SECTION 7
MAINTENANCE INSTRUCTIONS
7.1 INTRODUCTION
The following information sets out recommendations for the maintenance of this equipment.
Periodic maintenance, when carried out as specified, will help to prevent premature failure of
the equipment. Should a component fail or its operation become suspect the equipment
should not be used until the fault has been rectified.
7.2 PERIODIC MAINTENANCE
The following maintenance tasks are those required to help prevent premature failure of the
equipment. It is recommended that all the tasks should be carried out when specified.
PERIOD TASK
Daily when in use or on
completion of a job Clean the equipment.
Check all components are present (refer to packing list in
Section 5.2.1) and in good working order.
Check for correct operation of all the control devices.
Check all fasteners are properly tight.
Check and adjust gib strips, (toolpost and carriage). Nil
play but free moving.
Re-grind the cutting tools.
Wipe all components with a small amount of light machine
oil.
Weekly when in use Complete the daily tasks.
Check bearings. Grease or renew as required.
Check the drive motor, bearings, gears and vanes for
wear/damage, see manufacturer’s literature in Appendix D