●
The product complies with NCC Administrative Regula-
tions on Low Power Radio Waves Radiated Devices
：
Article 12
：
Without permission granted by the NCC,
any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or alter
original characteristic as well as performance to an
approved low power radio-frequency devices.
Article 14
：
The low power radio-frequency devices
shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio communi-
Precautions for safe use
Components of TX-RC-1
Functional settings and hotkeys of TX-RC-1
v��
Package contains
Smart remote controller/TX-RC-1
User Guide/Warranty
Thank you for choosing EZCon
®
Smart
remote controller TX-RC-1.
This Quick Instruction Manual explains the
basic installation and using procedures. For
the introduction of detailed product installa-
tion and troubleshooting, please visit the
official website at www.teamyoung.com.tw
for downloading.
Smart remote controller
Quick Instruction Manual
USB Cable
AAA Battery
●
To avoid the danger of electric arc to user and damage
of electrical switch contact, please do not plug or
unplug powered-on RX products.
●
Please download EZCon_PC-tools file in advance on
Team Young official website at www.teamyoung.com.tw.
For the first time of use, please select File/New, or select
File/Open file that has already been edited. After your
layout of each specified layer is edited, please save the
file.
After file has been edited, please use USB Cable to
connect laptop/PC with Smart remote controller and
press ”SET” button to enter into the transmission
mode. Then write the IP data of terminal points to
TX-RC-1.
cations is operated in compliance with the Telecommu-
nications Act. The low power radio-frequency devices
must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.
Power Key
• USB port-Micro-B-female connector
(For receiving)
• USB port-Type-A-female connector
(For transmitting)
●
Screen
Battery indicator
：
Red light indicates insufficient battery level and
suggests changing the battery.
Signal indicator
：
Blue light indicates that control signal is transmitting.
●
Button
Left
：
Switch to left
Right
：
Switch to right
Up
：
Switch upward
Down
：
Switch downward
●
Button
L/F
：
Turn off local luminaires
L/N
：
Turn on local luminaires
I
：
Pause(roll-up doors/curtains)
II
：
Lock(roll-up doors)
OFF
：
Turn off
ON
：
Turn on
STOP
：
Emergently stop
●
SET
Entering setting mode
●
Short press “SET” button to display the version of TX
firmware.
●
Long press “SET” button for 5 sec. to enter into setting
mode → select a specific operating mode
：
A.
Data transmission/importing mode - transmit data to the PC
(Hotkey: SET + Up direction button)
B.
RX Burning - Connect to RX & write IP of terminal points to
RX (Hotkey: SET + Down direction button)
C.
TX-RC-1 authorizing remoter - Transmit the layout of major
TX-RC-1 to other minor TX-RC-1 (Hotkey: SET +Left
direction button)
D.
TX-RC-1 receiver - Receive the layout of major TX-RC-1(Hot-
key: SET +Right direction button)
E.
Other mode
：
For setting sleep time, brightness of screen,
TX control range parameter, RX control range parameter
etc..
▶
Press “ON” button to confirm & execute the command.
▶
Press “STOP” button to return to the menu of layout.
