Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12
TKG VT 1021 - 160301
Assembly page 12/29
Fax +32 2 359 95 50
2.
Insert fan (2) onto the motor shaft (6) and attach it so that the
screw (3) touches the milling formed on the motor shaft (like in
the figure), (at the end of the work, check that the fan is
correctly secured).
3.
Couple the front grid (1) with the rear grid (5) and lock with the retention hooks. For safety
reasons, you must ensure the fastening with the appropriate locking screw (12) in the holes
provided on the edge of the grid, (the screw holes must be in the lower part).
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation:
select the desired speed by turning the switch to one of the following positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left):
this is selected with the button located on the motor body. To
stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low):
it is regulated by gripping the motor body and orienting it in the
direction desired; tighten the screw (9) to lock the motor housing in the desired position.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
Ensure that the fan is switched off from the supply mains before removing the guard (1).
Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
Do not immerse any part of the fan in water or other liquid: if this should happen, do not put
your hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance
and make sure that all the electrical parts are dry: in the case of doubt, ask for professionally
qualified help.
It is essential that the motor's air holes be kept from dust and lint.
Periodically check the electric cord for damage; its replacement requires a special tool:
contact an authorized service center, also for any repairs.
If the fan will not be used for long periods, it must be protected from dust and humidity; we
recommend storing it in its original packaging.
Should you decide not to use the appliance any more, we recommend making it
inoperative by cutting the power cord (after making sure you have disconnected the plug
from the socket) and make dangerous parts harmless if children are allowed to play with
them (such as the blade).
