Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
14
TKG VT 1020 - 160301
Assembly page 14/33
Fax +32 2 359 95 50
a.) Insert the
retaining screw
(21) into its seat,
the label "F" on
the column must
be at the front
b.) Tighten the locking
screw (7)
c.) Lock the retaining
screw with grip nut (8)
d.) Tighten the
clutch screw (up /
down)
4.
Insert the rear grid (19) onto the motor shaft (20), so that the
handle is at the top (like in the figure to the side), securing it using
the 4 screws provided (18.)
5.
Insert fan (16) onto the motor shaft (20) and attach it so that the
screw (17) touches the milling formed on the motor shaft (like in
the figure), (at the end of the work, check that the fan is correctly
secured).
6.
Couple the front grid (15) with the rear grid (19) and lock with the retention hooks. For
safety reasons, you must ensure the fastening with the appropriate locking screw (14)
in the holes provided on the edge of the grid, (the screw holes must be in the lower
part).
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation:
select the desired speed by turning the switch (7) to one of the following positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left):
this is selected with the button (13) located on the motor body.
To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low):
it is regulated by gripping the motor body and orienting it in the
direction desired; tighten the screw (10) to lock the motor housing to the desired position.
When not in use for long periods, the plug must always be removed from the socket.
