18
Repeat playback
You can listen to a set interval repeatedly .
1
During playback, press the REPEAT button at
the point where you want to start the repeat
playback interval.
The
appears on the display .
2
Press the REPEAT button at the point where
you want to end the repeat playback interval.
The
appears on the display .
The tape automatically rewinds to the starting point and play-
back starts, continuing to the ending point . When the ending
point is reached, playback stops temporarily, the tape rewinds
again to the starting point, and playback to the ending point
repeats .
Repeat playback stops automatically after 20 repetitions .
Press the stop (
8
) button to end repeat playback .
o
During repeat playback, only the REPEAT and stop (
8
) but-
tons can be used .
o
This function cannot be used for intervals of less than
10 counts on the tape counter between the starting and
ending points .
Using this unit, the sound from devices connected to the line input
connectors can be recorded on cassette tapes .
This unit can record to normal (type I) and chrome (type II) tapes .
o
This unit does not support recording to metal (type IV) tapes .
o
This explanation describes how to record from a connected
device to TAPE 1 or TAPE 2 . This unit also has functions that
allow recording a mix with sound input from a microphone
(page 21) and parallel recording to both TAPE 1 and TAPE 2 at
the same time (page 24) .
1
Put a cassette tape for recording in the
compartment.
o
Load it with the side to be recorded facing forward .
o
If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s) .
2
Press the RECORD (
0
) button to start record-
ing standby.
The
9
and
appear on the display .
o
If you want to record using the remote control, press the
two RECORD (
0
) buttons on the remote control at the
same time .
o
Press the stop (
8
) button to stop recording when in record-
ing standby .
Recording to cassette tapes
