Teac TD-SC1, Instructions For Use Manual

Page: 29 / 64

29
Group Setting name
Command
No.
R/W
Default value
(actual unit)
Command data (setting
value)
Operation
explanation
Digital Zero
Enable Digital Zero 2301 R/W 1: ON
0: OFF
1: ON
page 44
Digital Zero Limit Value 2302 R/W
99999
(999.99)
00000 to 99999 page 44
Digital Offset 2303 R/W
00000
(000.00)
−19999 to 19999 page 44
Select Data Output 2401 R/W
0: Display
Output
0: Hold value is output in
coordination with display
1: Input is output as is
page 44
*The last set command for Moving Average Data Set Size Selection (2002) or Moving Average Data Set Size (2004) is enabled. If only one is set, the other will
be set to 0: OFF.
6-6-5. Comparison settings
Group Setting name
Command
No.
R/W
Default value
(actual unit)
Command data (setting
value)
Operation
explanation
Comparison Value
Settings
High Limit Value (HI) 3002 R/W
10000
(100.00)
−99999 to 99999
page 45
Low Limit Value (LO) 3003 R/W
05000
(050.00)
−99999 to 99999
Comparison Pattern
Setting
3005 R/W 2: LO/OK/HI
0: OK/LO/HI
page 45
1: OK/LO/HI
2: LO/OK/HI
3: LO/HI/OK
4: LO/HI/OK
Comparison Mode
Setting
3006 R/W
0: Compare
Always
0: Compare Always
page 46
1: Compare During Stable
2: Compare Except Nearly Zero
3: Compare During Stable
Except Nearly Zero
4: Compare During Held
5: Disable Comparison
Hysteresis 3101 R/W
00000
(000.00)
00000 to 99999 page 47
Comparison Output
Pattern
3103 R/W
0: Standard
Output 0: Standard Output
1: Area Output
page 48
Nearly Zero 3104 R/W
00100
(001.00)
00000 to 09999 page 48
6. RS-485