Teac CR-H700DAB, Owner'S Manual

Page: 53 / 320

ENGLISH
53
Network standby setting
If you select “On“ for this setting, the unit turns on
and starts playback automatically when it detects an
AirPlay or DLNA signal.
Follow the menu items as follows:
”Setup Menu”
w
”Network”
w
”Wireless”
w
“Wired”
w
”Standby (Off)”, and then select “On”.
<
If “ON” is selected for this setting, the auto power off
function is not available.
Searching an access point
If you have moved or modified your network
environment, or if you have a problem connecting
to the Internet, perform the initial network setup to
establish the Internet connection again.
Follow the menu items as follows:
”Setup Menu”
w
”Network”
w
”Wireless”
w
”Search
AP”
Manual Internet setup
You can check and modify detailed settings of the
Internet connection.
Follow the menu items as follows:
To check the current network settings
”Setup Menu”
w
”Information”
To configure Wired LAN settings
Select “Setup Menu”
w
“Network”
w
“Wired”, and
then adjust “DHCP” and “Proxy Setting”.
To configure Wireless LAN settings
Select “Setup Menu”
w
“Network”
w
“Wireless”,
and then adjust “DHCP”, “SSID”, “Security”, “Key”, and
“Proxy Setting”.
To check the Radio ID of your unit
The Radio ID may be required when you contact our
customer support.
Follow the menu items as follows:
”Setup Menu”
w
”Information”
w
”MAC Address”
Network Configuration
Using iPod Wi-Fi login sharing
Using this function, you can send the Wi-Fi setting on your
iPod/iPhone/iPad to the CR-H700DAB. If you have already
finished the Wi-Fi setting for the CR-H700DAB, you do not
need to follow the steps below.
This function is supported by the iPod/iPhone/iPad with
iOS 5.x or later only.
The following explanations refer to an iPod, but they also
apply to use with an iPhone or iPad.
1 Connect your iPod to a Wi-Fi network.
2
Turn the unit on.
o
DO NOT connect a LAN cable to the unit.
3
Repeatedly press the SOURCE button to select
TUNER mode.
If the unit cannot be connected to a Wi-Fi network by
using “Internet Radio” or “Media Player”, the message
“Network problem” appears on the unit’s display.
Move on to the next step.
4 Repeatedly press the SOURCE button on the unit
or the iPod/USB button on the remote control to
select iPod/USB as the source.
5 Connect the iPod to the unit’s USB port using
the USB cable that was supplied with your iPod.
6 Press and hold the MENU button on the unit for
about 3 seconds.
7 The buttons “Allow” and “Ignore” appear on the
iPod. Select “Allow”.
The message “Wi-Fi Sharing connecting.” appears on
the unit’s display.
When the setting process is completed, the message
“Wi-Fi Sharing Success” will appear on the display.
8 After the message “Wi-Fi Sharing Success”
disappears, turn the unit off and then on.