Drive Installation Directions
The drive is operated in horizontal position. The eject
button is located on the right side of the panel. Installa-
tion position is not allowed to be tilted more than 15
degrees out of the horizontal position.
Jumpers for IDE Configuration
The strap is factory-preset as shown:
The TEAC CD-552E can be operated in the modes
Cable Select (CS), Master (MA) or Slave (SL).
Important:
During setting the mode be sure to switch off
respectively disconnect any voltages con-
nected to the drive (see section “Installation
and Connection”).
TEAC CD-552E CD-ROM Drive
Quick Installation Guide
page 1
Remarks:
X: jumper set
–: jumper not set (left open)
Installation and Connection
Note:
To use the TEAC CD-ROM drive an IDE
(ATAPI) controller is required. Usually it is in-
tegrated on the system board of your PC. The
drivers required for operating the CD-ROM
drive are a part of your operating system.
Very important:
Switch off your PC and any attached devices
and disconnect the power cord(s). It is not
sufficent to switch off the power switch! Do
the same if the CD-ROM drive is reconfigured.
(1)
Open the case of your PC and lift it off carefully.
(2)
Configure the CD-ROM drive if neccessary.
(3)
Locate a free slot for 5.25” drives and install the
drive using the provided four screws.
(4)
Connect the power cable and the 40-pin data cable
(assure the correct orientation, pin 1 is often
marked with a color stripe) to the drive. Connect-
ing in the wrong orientation may damage the drive
and the PC!
Power cable
40-pin IDE
data cable
Audio cable
Pin 1
CD-552E
(5)
Connect the provided audio cable to the sound
card.
Usually sound cards offer more than one connec-
tor to connect an audio cable to. Please refer to
the manual of the sound card to find the connec-
tor in question.
(6)
Close the case of the PC. Do not forget to connect
other devices and accessories if there are any.
C
S
S
L
M
A
Remarks
–
–
X
Master: CD-ROM drive is configured as first IDE
drive (basic setting).
This configuration can be used only if the drive is
connected to the second IDE controller
(secondary IDE). If a hard disk is already operated
at the secondary IDE controller (configured as
master) the jumper setting at the CD-ROM has to
be changed to slave.
–
X
–
Slave: CD-ROM drive is configured as second IDE
drive.
If there is only one hard disk in the PC the CD-
ROM can be operated at the same IDE connection
parallel to this hard disk. Important: The data rates
of both devices may be decreased.
X
–
–
Cable Select: Master/slave detection is achieved
by the controller.
S
L
M
A
C
S
Digital audio
output connector
Analog audio
output connector
40-pin IDE flat cable
connector
Power connector
Pin 1
