Teac CA-20, Instruction Manual

Page: 14 / 17

5. Function
5-1. Storing Data to CA-20
- Set to “Cut” on PC Link menu and measure the sensitivity.
- Push Enter key to store the measured sensitivity. Up to 100 data can be stored to CA-20 unit.
G
During “Full” is displayed, storing data is not available. In this case, delete stored data on CA-20.
Possible to delete stored data on “Clear Data List” menu.
5-2. Data List
- Display stored data on CA-20
- “Number, Sensitivity, DC bias voltage” are displayed. In case of transferring data to PC, Date and Time
information also transferred with above information.
5-3. Measurement Mode
- Two measurement mode “Single” and “Repeat” are available. “Single” means single shot measurement.
- After measured sensitivity being stable, CA-20 stops to shake base.
- Push select switch bit longer to measure sensitivity again.
- “Repeat” means continuous measurement. CA-20 doesn’t stop to measure sensitivity.
- Use “Repeat” mode in case of measuring low sensitivity accelerometer.
5-4. Auto Power Off
- In case of “Auto Power Off” is set, CA-20 power turns off after three(3) minutes from last operation.
- Turn off and turn on to start again
5-5. Time Setting
- Possible to set date and time on “Date Time” menu.
- Date time format is “YYYY.MM.DD HH:MM”. Up Down key allow to change each parameter and push
Enter key to determine parameter.
10