TE Connectivity AT-SC, Operating Instructions Manual

Page: 41 / 101

Page 41 / 101 ECOC: EGC0 ; LOC: AI
528050-1 412-18876 Rev. G
4 Safety
4.1 Designed Use
- Realization of crimp connections up to a cable Ø of 50mm² depending on the terminal design
The Pneum. Parallel Crimp Machine AT-SC is designed for use with the adapters described in section 12.
The adapters should only be used with the dies specified by TE. The Pneum. Parallel Crimp Machine
AT-SC with the adapter and dies should only be used for creating crimped connections! The standard die
adapter for the machine is the SDE Adapter (see chapter 12). Other applications on request.
4.2 Predictable Misuse
-
Every application which is not mentioned in chapter 4.1 „Designed Use“.
4.3 Responsibilities
The user of the Pneum. Parallel Crimp Machine AT-SC is responsible for making sure that all persons
involved in any way, either in the installation or in maintenance of the machine, have been thoroughly
trained on the system using the this instruction manual.
The user is also responsible for the training of operators and the instruction must include the following
aspects:
- Purpose of the machine
- Hazard zones
- Safety rules and regulations
- Functionality of the various components of the machine
- Proper operation of the machine
To assure full familiarization with the system, the training must be conducted in the native language of the
operators involved.
Staff qualifications required in conjunction with the use of the Pneum. Parallel Crimp Machine
AT-SC:
Installation
Set-up
Instruction Technical personnel with language proficiency in either English, German or
French, in
addition to the native language of the operator
Operation Through qualified personnel trained as indicated above
Maintenance
Service Technical personnel with proficiency in English, German or French
The safety instructions, warnings and precautions contained in the individual chapters must be strictly
observed by all users and operators.