5375 (08/13)
411-121100
INSTRUCTION
CLASS 1- Public
© 2021 TE Connectivity Ltd. family of companies.
All Rights Reserved.
| Indicates Change
TE Proprietary & Confidential Information
Class I Data Classification - See Policy TEC-02-04
7 of 15
Rev [1]
8 October 2021
5. OPERATION
Once you have installed the
AMS300
and connected the power supply and data
cable, you can switch the plotter on.
Important
:
Before switching the device on please ensure that there are no objects on the
writing/plotting area which might prevent the writing arm from moving freely. All
settings and commands are entered using the control panel.
ON/OFF
bu tt o n s
The
ON/OFF
buttons are used to activate and deactivate the device. When the plotter is
switched on, the writing arm moves to the top right-hand corner of the labelling area and
auto calibration takes place. The green light comes on when the system is ready for use
and to receive data from the PC.
Clear
buffer
If the
AMS300
contains data, the yellow light will come on. You can delete this data by
pressing the
Clear buffer
key.
To do this the system must be in stop mode (red light on).
