1
of 5
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.te.com
.
Instruction Sheet
408-6757
25 FEB 15
Rev F
WIRE SIZE
(AWG)
DIE ASSEMBLY FOR●
AMPLI-BOND* TERMINALS
AND SPLICES (408-1758)
TERMINYL* TERMINALS
AND SPLICES (408-1729)
AMPOWER* PRE-INSULATED
TERMINALS AND SPLICES (408-1729)
8
48752-1 Mod. W
47820
---
6
48753-1 Mod. W
47821
---
4
48754-1 Mod. W
47822
---
2
48755-1 Mod. W
47823
47823
●
Reference instruction sheet in parenthesis for information on die assemblies.
Figure 1
1.
INTRODUCTION
Hydraulic Hand Tool 59974-1 is designed for crimping the terminals and splices listed in Figure 1. Read these
instructions thoroughly before using the hand tool.
NOTE
Dimensions in this instruction sheet are in metric units [with U.S. customary units in brackets]. Figures and illustrations are for
identification only and are not drawn to scale.
Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY.
2.
DESCRIPTION
(Figure 1)
The hand tool has a stationary lever and a movable lever. These levers are compressed to pump hydraulic fluid
behind the ram, moving it forward and thereby closing the dies. After the crimping is complete, the movable
lever is turned to depress the plunger, and the moving die retracts to its original position, completing the
crimping cycle.
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Hydraulic Hand Crimping Tool 59974-1
Stationary (Reservoir)
Lever
Cap
Setscrew
Plunger
(Pressure
Release)
Movable Lever
Latch Pin
(Removed)
Striker (Shown in Actuated
Position to Depress Plunger)
Ram (Advanced to Show
Setscrew for Moving Die
Yoke
(Opened)
Setscrew (Holds
Stationary Die)
OR
IGIN
A
L
IN
STR
U
C
TION
S
