Instruction Sheet
Fiber Optic Cleaver
408--10086
LOC B
1
of 4
E
2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.te.com
21 Mar 11 Rev C
1871696- 1
Scale
Fiber
Slide
Button
Fiber
Clamp
Carriage
Cleaver Base
1. INTRODUCTION
These instructions describe the use of Fiber Optic
Cleaver 1871696--1, shown above.
The cleaver can be used for LightCrimp* Plus, MT--RJ
Jack, CORELINK*, and Fusion Splice applications.
Fibers may be cleaved using a hand--held (preferred)
method, or a table--top (alternate) method.
2. OPERATION
2.1. Hand- Held Operation (Preferred Method)
2. Press down on the button and slide
the carriage back (in the direction shown).
1. Open the fiber clamp.
3. Move the fiber slide back until it stops.
4. Clean the stripped fiber with a solution
of greater than 91% ISO alcohol. (99% ISO
alcohol is recommended.)
5. Place the stripped and cleaned fiber
into the slot at the desired cleave length.
