Crimp Head
Mounting Holes
Typical Closed-End Splice
Crimping Head for Use with
DAHT Assembly (Ref)
DAHT Adapter
Assembly
Retract Button
Battery Powered
Hand Tool
Battery Lock
Battery
Cartridge
1725839-1
Quick-Release Pins
© 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 4
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
LOC B
408-10032
Closed-End Splice Crimping Heads 1-45216-0
and 1-45219-2 (For Use with Battery Powered
Double Action Hand Tool Kit)
05 DEC 11 Rev B
Figure 1
1. INTRODUCTION
Crimping Heads 1-45216-0 and 1-45219-2 are
designed to crimp closed-end splices onto solid or
stranded copper wire size 22-10 AWG using Battery
Powered Double Action Hand Tool Kit 1213804-[ ] .
Refer to Figure 1 for tool components and Figure 2 for
Closed-End Splice product.
NOTE
i
The crimping heads can also be used with the 626
Double Action Pneumatic Tool Adapter 1213563-1.
This instruction sheet provides recommended
procedures for wire preparation, crimping head
installation, crimping, and maintenance and
inspection. For information concerning tool setup and
operation, refer to Customer Manual 409-10056
packaged with the battery tool kit.
NOTE
i
Dimensions are in metric units with [inches in
brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Reasons for reissue are provided in Section 7,
REVISION SUMMARY.
2. DESCRIPTION
The crimping head consists of integral jaws which
close in an arc-like motion. After an operator locates
the terminal or splice between the crimping jaws and
inserts the stripped wire, the tool is activated to crimp
the terminal or splice to the wire.