SW-000103
Document Number: SW-000103
Page 19 of 51
Revision: 1.1
4
SENSOR DATA MODE
1.
Select
Sensor data
window
This window is the most important section of the app. This allows users to stream multi-sensor data (from IMU,
magnetometer, temperature, humidity, ultrasonic, and pressure sensors) and record that data into log files. It also
provides tuning parameters to finetune the desired raw sensor data.
Note:
All the sensors, except Chirp Range sensor CH101, are physically mounted inside the SmartBug module. The
CH101 connector comes with WiFi + SD Add-On board. The physical connection of CH101 module with the Add-On
board through FFC Cable is shown below:
