BA-PZ3_ML / F0354400
19
7.5
Working with module
„
Standard
“
This module is used for various applications on
non-electrically conductive substrates / materials
such as plastics, ceramics, glass, natural fibres,
leather, textiles etc. The range of the permissible
working distance is approx. 2 to 10 mm.
Electrically conductive substrates such as metals
or conductive polymers cannot be reliably treated
with this nozzle.
When treating electrically conductive substrates /
materials, arcing can occur if the distance is too
small. In this case the unit will stop plasma
generation after approx. 0,5 seconds.
7.6
Working with module
„
Nearfield
“
The module "Nearfield" was especially designed
for the treatment of electrically conductive
substrates / materials such as metals or
conductive polymers. Even partially conductive
materials such as carbon fiber reinforced plastics
(CFRP) should be treated with this module.
The device can only generate a surface activation
if an electrically conductive substrate is in front of
the device within the range of the permissible
working distance. This is approx. 0.5 to 2.0 mm. If
the distance is greater, plasma generation may
not be possible under certain circumstances,
depending on the material and geometry of your
substrate.
If too great a distance is selected, the unit
automatically stops plasma generation after
5 seconds.
Caution - hot surface!
The module can become hot during operation. Do not touch the module immediately after
operation. Do not touch the substrate with the module during operation.
7.7
Working with other modules
It is planned to develop further modules for this device. Please refer to the corresponding
operating instructions enclosed with these modules.
(ES) Equipements Scientifiques SA - Département Composants & Modules - 127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 84 - Fax. 01 47 01 16 22 - e-mail: [email protected] - Site Web: www.es-france.com
