EN
BA-PZ3_i_ML / F0354901
23
6.2
Carrying out surface treatment
Depending on the type and condition of your substrate, pre-cleaning before the plasma
process can improve the overall outcome.
The effect of the treatment depends on the working
distance, treatment time, speed and
consistency of movement, as well as the material to be treated.
Treatment examples can be requested directly from
Relyon Plasma
GmbH.
6.3
Measures to take after the surface treatment
To achieve an optimum result, it is important that as little time as possible elapses after the
plasma treatment and that the treated surface is not touched or contaminated.
Cleaning the surface AFTER the plasma treatment is not recommended.
Since the workpiece may heat up depending on the type and duration of the plasma
process, it may be necessary to allow the workpiece to cool down first before the next
process step is executed. This is to ensure that the process will not be negatively impacted
by the introduction of heat (e.g. in certain bonding processes).
Caution
– Hot surface!
The workpiece to be treated may be heated up by the plasma process, depending on the
process parameters. If necessary, allow the workpiece to cool down before handling it.
