•
hard disk* connected to the primary IDE* port* as the master* device and CD-ROM drive
connected as the slave*; nothing connected to the secondary IDE* port*;
•
hard disk* connected to the primary IDE* port* as the master* device; nothing connected to
the secondary IDE* port*.
Setting the writer’s jumpers
The jumper block at the rear of the writer determines its MASTER* or SLAVE* setting. You can
change this setting if required by repositioning the jumper in the jumper block.
The TDK DVD-R/RW writer is delivered with its jumper set to master*. This will work with most
commonly found PC configurations.
CHANGING THE JUMPER ON YOUR INTERNAL TDK DVD-R/RW WRITER
As shown in Figure 6, the TDK DVD-R/RW writer arrives from the factory with its jumper set to
MASTER*. (A setting is enabled if the jumper is installed on a pair of jumper pins and disabled
if the jumper is removed.)
Figure 6:
Factory jumper settings at the rear of the writer
Jumper settings for master*, slave* or cable select* mode:
The writer’s master*, slave* or
cable select* setting is determined by the position of the jumper. To change the setting from
master* to slave* or cable select*, you must reposition the jumper. For example, changing the
TDK DVD-R/RW writer to a SLAVE* setting entails repositioning the jumper to cover the “SL”
set of pins, leaving the other pins uncovered. Resetting the writer to cable select* involves
moving the jumper to cover the “CS” set of pins.
CS SL MA
reserved
22
