6
7
2800 Laura Lane • Middleton, WI 53562
|
800.288.9383
|
www.tcsbasys.com
Building Automation Systems
6
7
Installation
Material List
• QWL2040 Panel
•
External Power Supply
Wall Mounting
The Panel is designed for wall mounting using four #10 pan head screws.
The unit MUST be powered down while mounting to the wall.
When selecting a location to mount the Panel, be sure to allow space for cable connections.
Locate the Panel away from excessive dust, heat sources, moisture or direct sunlight. The ideal environment is a server
room. The temperature of the room should not exceed 77ºF (25ºC); good ventilation is mandatory to provide sufficient air
cooling.
Wiring Access Port
The Panel comes with a one-inch wiring access port pre-drilled in the top of the unit. Drilling into the unit to add additional
wiring access ports is at your own risk. Use caution when drilling into the unit; be sure to capture all metal shavings.
The unit MUST be powered down while drilling into the unit.
Factory IP Network Address Configuration
The Panel is typically purchased pre-configured to customer-specific IP networks and no additional software configuration
is required. If your Panel was purchased without pre-configuration, it will be shipped with DHCP client enabled.
The IP network configuration page is accessible through a web browser via a computer, e.g., a laptop, that is physically
connected to the unit with a standard RJ-45 Ethernet cable. Contact your network administrator to determine the local IP
address (refer to the MAC address available on the product label).