TCS ISW3330, Product Information

Page: 4 / 20

4 07/2015
TCS TürControlSysteme AG, TCS Hotline Germany: hotline@tcsag.de Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129 PI_ISW3330-uk 2 A
Scope of delivery
1 x indoor station ISW3330 (S-11912): upper cover, lower cover
1 x desktop accessory (with connection cable 3 m)
product information
instruction manual
Safety regulations
!
Attention! Mounting, installation, commissioning and repair of electronic devices have
to be carried out only by qualified electricians. Thus, the standards and instructions for
the installation of systems have to be observed!
When installing TCS: BUS
®
systems, the general safety regulations for telecommunication
systems according to VDE 0800 must be observed. Inter alia:

separated conduit of heavy and low current lines,

minimum distance of 10 cm in case of a common conduit,

use of separators between heavy and low current lines within shared cable ducts,

use of standard communication lines, e.g. J-Y (St) Y with 0.8 mm diameter,

existing lines (modernisation) with deviating cross-sections can be used in compliance
with the loop resistance.
Installation
– protective measures
!
With suitable measures to protect against lightning, it has to be ensured that a voltage
of each 32 V DC is not exceeded at the connections a, b, P, E.
Intended use

The ISW3330 are indoor stations for hands-free talking (manually controlled duplex
communication).

They are intended to be operated exclusively in TCS systems with call center!

They are suitable for surface-mount (installation over flush-mount socket) or for desktop
installation with desktop accessory ZIT3030-0010.

3-wire technique necessary!
!

The indoor station ISW3330 must not be used in call systems according to DIN VDE
0834 and EN50134. According to DIN 77800, a separate safeguard for emergency
calls has to be installed.

A system equipped with an indoor station ISW3330 is not an emegency call system
according to the above mentioned standards.

The indoor station ISW3330 must not be used in life-saving or life-sustaining sys-
tems.

Further, the combination of system parts which fulfill the above mentioned standards
is not permitted.