TC Electronic UpCon, Manual

Page: 61 / 114

UpCon remote control
UpCon English Manual (2014-10-07) 58
Processing section
Audio processing in your UpCon can be con-
trolled via GPI or SDI metadata.
When GPI or SDI metadata are being used to
control the device, a blue LED on the respective
Engine pages will indicate that their features are
remote-controlled.
GPI and SDI buttons
Use these buttons to activate audio processing
remote control via GPI 2 input or incoming SDI
metadata.
Please note that this is a “radio button” set – only
one of them can be active at a time.
“Enable” buttons that control the same function
can be found on the Remote – GPI page (in the
GPI 2 – Processing Control section) and on the
Remote – SDI page.
Current Processing status field
The Current Processing status field shows the
current audio processing details no matter if GPI
or SDI metadata is used for control.
“Normal” display
If “Normal” is displayed, audio-processing is not
remote-controlled, and the unit works as speci-
fied by the current Engine preset.
“N/A” display
“N/A” (“not available”) indicates that the currently
selected function is not available/applicable to
the algorithm currently loaded in the Engine.
“N/A” also indicates that the device is not re-
mote-controlled, and the unit works as specified
by the current Engine preset.
Other displays
All other values shown in the Current Process-
ing status field show which features are currently
controlled via GPI or SDI. The possible values
are a combination of the parameters Function,
Engine and Status as set on the Remote – SDI
or Remote – GPI page in the GPI 2 – Processing
Control section.
When using SDI, the same information is shown
on the Remote – SDI page in the Current Pro-
cessing status field.
Remote – GPI