11
HALL OF FAME 2 X4 REVERB User Manual
8. MIDI
The HALL OF FAME 2 X4 is equipped with MIDI IN and THRU jacks, allowing an
external MIDI controller to control preset and parameter changes.
The following charts detail the control and program changes accepted by
HALL OF FAME 2 X4. Note that the MIDI receive channel is 5.
Initiating a program change will load the associated preset and un-bypass the
pedal. To bypass the currently-selected preset, either use program change 1
(all FX off) or use the bypass command (cc 12) if you need to toggle the same
preset on/off.
Preset Changes
* Note that depending how the MIDI controller handles program change messages (0-127 or 1-128),
the program number may need to be 1 digit higher than what is listed in the chart.
Parameter Control
* CC 0-63: FX On, CC 64-128: FX Off. If used after preset selection, triggering FX On will retain current settings and
not reload preset.
Note that the modifiers (knobs) can control up to 3 user-selectable
parameters, so MIDI control may affect more than just the parameters listed.
Custom controller setups can be arranged via the TonePrint app, and each
TonePrint slot can store unique modifier configurations.
9. Links
Support resources
•
TC Electronic Support:
•
TC Electronic – product software:
tcelectronic.com/support/software/
•
TC Electronic – all product manuals:
tcelectronic.com/support/manuals/
•
TC Electronic user forum:
TC Electronic on...
•
the Web:
•
•
plus.google.com/+tcelectronic/
•
Twitter:
•
Preset number
Program change
Bypass All
1
Preset A / Bank 1
2
Preset B / Bank 1
3
Preset C / Bank 1
4
Preset D / Bank 1
5
Preset A / Bank 2
6
Preset B / Bank 2
7
Preset C / Bank 2
8
Preset D / Bank 2
9
Parameter name / destination
Control change
Decay (modifier 3)
1
Pre Delay (modifier 4)
2
Tone (modifier 1)
3
Level (modifier 2)
4
MASH switch (active FX engine)
5
Exp Pedal (jack must be unplugged)
11
Bypass (active FX engine)
12*
Summary of Contents for HALL OF FAME 2 X4 REVERB
Page 14: ......
