8
4) Install overflow fitting. It goes off to the right in the photo below, through the fuselage. The
overflow/startup tank then can rest on the wing.
5) Plumb tanks as shown. There is plenty of room to add a smoke tank in front of these tanks if
desired.
6) Attach the TBM BFT (bubble-less fuel tank or equivalent) to the BFT mount and glue in place
with Hysol where shown.
Summary of Contents for DV8R
