17
Elevator, Rudder and Aileron Servo Installation
1) All the servos for the control surfaces are similar. Install the servos using the mounting blocks
(provided) as shown. Glue the mounting blocks to the hatches after you trim them to the
correct size. We provide 4 wood blocks 1” x ¾” x ¼” for this purpose. BE SURE to drill holes
for the servo screws to avoid splitting the wood. We don’t use the rubber servo mounts or
grommets. Jets have little vibration, so we just screw the servo directly to the wood.
Summary of Contents for DV8R
