TB Wood's X4, User Manual, Page: 59 / 98

X4 AC Drive User’s Manual Chapter 7: X4 Parameters
1428D-0607 - 51 -
© 2007 TB Wood’s All Rights Reserved
102 Output Freq Read-Only
Range: 0.0 to 400.0 Hz
Levels 1,2
Parameter 102, the Output Frequency parameter, shows the frequency being applied to the motor connected to the
drive (ramp).
103 Output Voltage
Read-Only
Range: 0 to 600 V
Levels 1,2
Parameter 103, the Output Voltage parameter, displays the output voltage of the drive.
104 Output Current Read-Only
Range: 0.0 to 200.0 A
Levels 1,2
Parameter 104, the Output Current parameter, displays the output current of the drive.
105 Drive Load
Read-Only
Range: -200.0% to 200.0%
Levels 1,2
Parameter 105, the Drive Load parameter, shows the percentage torque of the drive when operating below the knee
frequency. It displays Load Torque if the frequency is below FKNEE, and displays Power if above FKNEE.
The output current is measured with the motor power factor applied to an accuracy of ±20%.. The parameter value is
positive when the motor is pulling a load (“motoring mode”) and negative when being pulled by a load (“regenerative
mode”).
106 Load Torque
Read-Only
Range: -200.0%-200.0%
Levels 1,2
Parameter 106, the Load Torque parameter, displays the load torque of the drive.
107 Drive Temp Read-Only
Range: -20.0 to 200.0 °C
Levels 1,2
Parameter 107, the Drive Temp parameter, shows the actual temperature of the drive’s heatsink. The drive will fault
when the internal temperature reaches 85
°C.
108 Total Run Time
Read-Only
Range: 0.0 - 6553.5 h
Level: 2
Parameter 108, Total Run Time, is a resettable timer for drive operation. To reset the timer, enter 10 in parameter 801,
Program Number.
109 Power On Hours Read-Only
Range: 0 - 65535 h
Level: 2
Parameter 109, Power On Hours, displays how long the drive has been powered up.
110 Stator Freq Read-Only
Range: 0.0-400.0 Hz
Level: 2
Parameter 110, Stator Frequency, displays the frequency the drive is applying to the motor stator.
111 DC Bus Voltage Read-Only
Range: 0-1000 Vdc
Level: 1,2
Parameter 111, DC Bus Voltage, displays the voltage on the DC bus.
115 Drive Power Out Read-Only
Range: 0.0%-200.0%
Level: 2
This parameter displays the power being output by the drive in terms of drive rating. The measurement is calculated by
scaling the Load Torque value by the ratio of Volt-Amps to Rated Volt-Amps, and adjusted by Output Frequency.
Table 7-2: Description of X4 Parameters (Page 2 of 26)