145
/
188
d. Check whether the surface of the removed hose is
aging, cracked, damaged, abraded, etc. Wipe up the
remaining brake fluid with a non-woven cloth, and then wrap
the ends of the hose with cling film or a plastic bag to
prevent foreign matter from entering. Check whether the
cable sheath of the wheel speed sensor cable is damaged. If
the sheath is frayed, it can be glued with electrical tape to
prevent short-circuit.
RC-HU and wheel speed sensor (rear wheel)
a. Find 3 cable ties on the frame tube above the fuel tank
on the right side of the frame, and cut the cable ties
⑴
that
bind the RC-HU hose in the middle. Do not cut the other 2
cables. When reinstalling, make sure that the cable tie
cannot be tied too tightly, and a certain gap should be left.
b. Find the plug of the wheel speed sensor
⑵
on the right
side of the middle part and unplug it.
c. First remove the 3 pieces of wire clamp
⑷
, and then pull
out the wheel speed sensor
⑵
and the RC-HU hose from the
4 pieces of oil pipe clamp
⑶
. If you need to remove the
tubing clamp (3), you can use 4# inner hexagon to remove
the bolts and then you can take it off.
d. Pull the RC-HU head out of the gap between the
auxiliary water tank and the frame.
e. Pull out the RC-HU hose and wheel speed sensor wire
from the rear inner mud plate.
f. Pull out the wheel speed sensor from the clamp
⑸
,
remove the bolt
⑹
with a 4# inner hexagon, and then
remove the wheel speed sensor from the car. If you need to
remove the clamp
⑸
, you can use 4# inner hexagon to
remove the bolt
⑹
that fixes the clamp.
g. Check whether the surface of the removed hose is
aging, cracked, damaged, abraded, etc. Wipe up the
remaining brake fluid with a non-woven cloth, and then wrap
the ends of the hose with cling film or a plastic bag to
prevent foreign matter from entering. Check whether the
cable sheath of the wheel speed sensor cable is damaged. If
the sheath is frayed, it can be glued with electrical tape to
prevent short-circuit.
Summary of Contents for Zontes ZT125-M 2022
