TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 182 / 188

182 / 188
Disassembly of the storage box
Refer to the steps of "Removing the Stepper Motor and
Cleaning the Carbon Deposit".
Disassembly of the rear hand rest
a. Remove 7 pcs buckles from the bolt, and use the 4#
inner hexagon to remove two pcs M6x12 bolts; Remove 5 pcs
M8x25 bolts with 12# sleeve; Use 4# inner hexagon to
remove 2 swell nails from the rear handrail; Hold the rear
armrest anywhere with both hands, lift the rear armrest up
in the direction of the big arrow and remove the rear
armrest.
b. Flip the rear armrest to the back and remove the 2
M6×12 bolts on the left side using a 4# hexagon socket to
remove the left buffer rubber of the rear armrest (L in the
figure), and remove the right buffer glue (R in the figure) in
the same way. Remove the 5 M6×12 bolts at the rear of the
4# hexagon socket, remove the flanging bushing and the
flanging bushing buffer glue, and then remove the bottom
plate.
Disassembly of the left and right tail cover
a. Remove the 4 swell nails from the apron by 4# socket.
b. Use a 4# inner hexagon to remove the two M6×14 bolts
which fix the front of the tail skirt.
c. Grasp the mark of the fuel tank middle cover by hands
and press it down (green rectangle 1; here is the color of the
parts for easy identification, the middle of the fuel tank cover
is black, and the right part of the fuel tank cover is gray. The
tail skirt is red) With the other hand, grab the tail skirt mark
(green rectangle 2) and pull it up until the two buckles at the
junction of the tail skirt and the middle part of the fuel tank
cover (yellow area) are separated;Hold the mark on the tail
skirt (green rectangle 4) with one hand, and then hold the
mark on the right part of the fuel tank cover (green rectangle
3) with one hand and pull it out until the 2 buckle positions
and 2 clip pins at the junction between the tail skirt and the
right part of the fuel tank cover (yellow area) are
separated;Finally, grab the end skirt marks (green rectangles
5, 6) and pull in the direction of the arrow. Remove the right
skirt cover.
d. Use the same method to remove the left side of the tail-
cover board.