TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 176 / 188

176 / 188
b. Hold the mark on the front sun visor (green rectangle)
with your hand, pull it up in the direction of the arrow, and
take out the front sun visor.
Removal of the front cover
a. Use 4# inner hexagon to remove one M6×14 bolt on the
front cover. Then use 4# inner hexagon to remove the 2 swell
nails on both sides of the front cover.
b. Raise the windshield rocker arm to the highest position,
then grab the mark on the front cover (green rectangle) with
your hand, and pull it up in the direction of the small arrow;
pull out the two mushroom buttons (blue circles) on the
front cover After exiting; continue to grasp the mark on the
front cover (green rectangle) and pull it diagonally upward
according to the big arrow until the 6 buckles on both sides
of the front cover (yellow area, 3 on the left and right) are all
pulled out.
c. After pulling out all the buckles, grasp the mark on the
front cover (green rectangle) with your hand, and pull it
down in the direction of the arrow until the front cover is
removed.
Removal of the front panel
a. Use 4# inner hexagon to remove the two M6×12 bolts
on the front panel.
b. Grasp the mark on the front front cover (green box)
with your hands, and pull out according to the arrow until
the mushroom head (small arrow) on the right side of the
front front cover is pulled out; use the same method to
remove it The mushroom head on the left side of the front
front cover.
c. Grasp the mark on the front cover (green rectangle) with
your hands, and pull it up in the direction of the arrow until
the two positioning buckles (blue circles) of the front front
cover and both sides of the front front cover are fixed.
(Yellow area, 6 locations on the left and right), pull out the 12
buckles, and remove the front cover.
Disassembly of headlights
a. Use the 4# inner hexagon to remove the 4 M6×14 bolts
around the headlight; use a cross to remove the 2 fixed
headlight self-tapping Nail.