Taylor RD30, Operator'S Manual

Page: 18 / 38

6-2
OPERATING PROCEDURES
Models RD30/RC25
Operating Procedures
6
4. Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
Figure 6-4
5. If the blades are in good condition, place the rear
scraper blade over the rear holding pin (knife edge to
the outside). Holding the blade on the beater, turn it
over and install the front blade the same way.
Figure 6-5
6. Holding the blades in position, insert the beater
assembly into the freezing cylinder, and slide the
assembly into position over the driveshaft. Turn the
beater slightly to make sure that the beater is
properly seated.
Figure 6-6
Note: When in position, the beater will not protrude
beyond the front of the freezing cylinder.
Figure 6-7
7. Install the plastic guide bearing on the short end of
the torque rotor. Slide the O-ring into the groove on
the long end of the torque rotor and lubricate the

O-ring . Do not lubricate the guide bearing.
Figure 6-8
8. Insert the torque rotor (guide bearing end first) into
the pilot hole in the center of the driveshaft. The hole
in the torque rotor shaft should be rotated to the

12 o’clock position.
Figure 6-9
11547
11548
11562
11563
Apply the appropriate
Taylor approved food safe lubricant.
HP