6-4
OPERATING PROCEDURES
Models RD30/RC25
Operating Procedures
6
16. Place the large O-ring into the groove on the back
side of the door and lubricate the O-ring. Install the
door bearing onto the hub on the back side of the
door with the flanged end of the bearing facing the
door.
Figure 6-16
Note:
Do not lubricate the door bearing.
17. Position the door on the freezer studs at the front of
the freezing cylinder. Press the door firmly into place.
Note:
The torque rotor will protrude through the hole
in the center of the door.
Figure 6-17
18. Install the handscrews on the studs. Tighten the
screws equally, in a crisscross pattern.
Do not
overtighten the handscrews.
Figure 6-18
19. Position the torque arm by inserting it through the slot
in the torque switch arm and down into the hole in the
torque rotor which protrudes from the door. Verify
proper installation by moving the torque rotor back
and forth to make sure it moves freely and easily.
Figure 6-19
20. Install the front drip tray and the splash shield under
the door spout.
Figure 6-20
Apply the appropriate
Taylor approved food safe lubricant.
LUBRICATE AROUND
GASKET ONLY.
HP
Summary of Contents for RD30
Page 16: ...5 2 USER INTERFACE Models RD30 RC25 User Interface 5 Notes...
Page 26: ...6 10 OPERATING PROCEDURES Models RD30 RC25 Operating Procedures 6 Notes...
Page 32: ...9 2 PARTS REPLACEMENT SCHEDULE Models RD30 RC25 Parts Replacement Schedule 9 Notes...
Page 38: ...11 4 LIMITED WARRANTY ON PARTS Models RD30 RC25 Limited Warranty on Parts 11 Notes...
