Taylor Horizon 8756, Operator'S Manual

Page: 25 / 58

OPERATING PROCEDURES
6-3
Model 8756
Operating Procedures
6
8. Install the beater shoes. Slide the beater assembly
the rest of the way into the freezing cylinder.
Figure 6-7
9. Make sure the beater assembly is in position over the
driveshaft. Turn the beater slightly to make sure it is
properly seated. When in position, the beater
will not
protrude beyond the front of the freezing cylinder.
10. Repeat these steps for the other side of the
freezer.
Freezer Door
1. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: door
bearings, door gaskets, draw valves, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bores. Replace any damaged parts.
2. Place the large rubber gaskets in the grooves on the
back side of the freezer door.
Figure 6-8
3. Slide the white plastic front bearings over the baffle
rods. Make sure that the flanged end of the bearing is
resting against the freezer door.
Do not lubricate the
gaskets or the front bearings.
Figure 6-9
4. Slide the O-rings into the grooves on the prime plugs.
Apply an even coat of lubricant to the O-rings and the
shafts.
Figure 6-10
11532
11430
11434
11067
Apply the appropriate
Taylor approved food safe lubricant.