Taylor C801, Operating Instructions Manual

Page: 7 / 70

3 C801/C801R/F802/P802/C803/C803R/C804 To the Installer
Setup and Checkout Instructions
Step 1
Install the panels, starting with the bottom. Install the
panels under the node board modules, the lane
dividers (staging side) and the accessory brackets.
Step 2
Install the node board modules.
Step 3
Tighten all screws.
Step 4
Once the electrical connections are completed,
install the box cover and turn the grill on.
Step 5
Wait for 45 minutes for the grill to reach stable
temperatures before proceeding to the next step.
The grill will indicate it is ready to cook in
approximately 15 - 20 minutes.
CAUTION: The grill will be hot. Wear
proper protective equipment to avoid severe burns
from high temperatures.
Step 6
Check the platen lift mechanism and adjust, if
needed (not applicable to P802).
(See Lift/Latch
Instructions in the Service Manual.)
Step 7
Install the back panel.
Step 8
The platen should be lowered onto the lower plate
and the gap settings should be properly calibrated.
To close the platen, touch and hold the red button
corresponding to the desired platen. A cook cycle
will not start and the display will read “Standby”.
Release the button after the platen has closed.
(See
Platen Gapping Procedures in the Service
Manual.)
Step 9
Once the gaps are set, install the cook side back
splash, lane divider, and the release sheets.
Step 10
Cook one run of product on each platen to check the
product appearance and the finished product
temperature.
(Internal temperature must be above
175°F / 79°C.)
Step 11
Check the “cook to order” and back up staging.
Step 12
Fill out the checkout card and the work order /
invoice.
Ventilation and Clearance
To ensure proper operation of this appliance, it must
be installed so that the products of combustion are
efficiently removed.
After set up, do not store anything on top of
the grill. Failure to follow this instruction may result
in a fire hazard.
Grease Disposal Container
In order to comply with NSF Standard 4
requirements, an appropriate grease disposal
container must be provided. This container is
supplied by the KES, not the Taylor Company.