Taylor C302, Operator'S Manual

Page: 9 / 52

Section 2
2-1
Model C302
To the Operator
2
To the Operator
The freezer you have purchased has been carefully
engineered and manufactured to give you dependable
operation.
The Model C302, when properly operated and cared for,
will produce a consistent quality product. Like all
mechanical products, this machine will require cleaning
and scheduled maintenance. A minimum amount of care
and attention is necessary if the operating procedures
outlined in this manual are followed closely.
This operator's manual should be read before operating
or performing any maintenance on your machine.
Your freezer will not eventually compensate and correct
for any errors during the setup or filling operations. Thus,
the initial assembly and priming procedures are of
extreme importance. It is strongly recommended that all
personnel responsible for the equipment's operation
study these procedures together in order to be properly
trained and to make sure that no misunderstandings
exist.
If you require technical assistance, please contact your
local authorized Taylor distributor for service.
Note: Your Taylor warranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor distributor, and only if all required
service work is provided by an authorized Taylor service
technician. Taylor reserves the right to deny warranty
claims on machines or parts if Taylor-unapproved parts or
incorrect refrigerant were installed in the machine,
system modifications were performed beyond factory
recommendations, or it is determined that the failure was
caused by abuse, misuse, neglect, or failure to follow all
operating instructions. For full details of your Taylor
warranty, please see the Limited Warranty section in this
manual.
For additional information regarding applicable local
laws, please contact the municipal facility and/or local
distributor.
Compressor Warranty Disclaimer
The refrigeration compressor(s) on this machine are
warranted for the term stated in the Limited Warranty
section in this manual. However, due to the Montreal
Protocol and the U.S. Clean Air Act Amendments of
1990, many new refrigerants are being tested and
developed, thus seeking their way into the service
industry. Some of these new refrigerants are being
advertised as drop-in replacements for numerous
applications. It should be noted that in the event of
ordinary service to this machine's refrigeration system,
only the refrigerant specified on the affixed data label
should be used.
The unauthorized use of alternate
refrigerants will void your Taylor compressor warranty. It
is the machine owner's responsibility to make this fact
known to any technician he or she employs.
It should also be noted that Taylor does not warrant the
refrigerant used in its machines. For example, if the
refrigerant is lost during the course of ordinary service to
this machine, Taylor has no obligation to either supply or
provide replacement refrigerant either at billable or
unbillable terms. Taylor will recommend a suitable
replacement if the original refrigerant is banned,
obsoleted, or no longer available during the five-year
Taylor warranty of the compressor.
From time to time Taylor may test new refrigerant
alternates. Should a new refrigerant alternate prove
through Taylor's testing that it would be accepted as a
drop-in replacement for this machine, the disclaimer in
this “Compressor Warranty Disclaimer” section will not
apply to the use of the alternate refrigerant approved by
Taylor.
To find out the current status of an alternate refrigerant
as it relates to your compressor warranty, call Taylor or
your local authorized Taylor distributor. Be prepared to
provide the model/serial number of the machine in
question.
Note: Continuing research results in steady
improvements; therefore, information in this manual is
subject to change without notice.