5-8
USER INTERFACE
Model C302
User Interface
5
Product Light
When the light is continuously lit (not flashing), it
indicates that there is an OUT condition for syrup, water,
or CO
2
.
When the light is flashing, it indicates that the product is
not at serving viscosity. This will occur during the initial
freeze down, a Defrost cycle, and a Fault condition
during Power Saver modes.
Sampling Valve
The sampling valve is located behind the lower front
panel. The sampling valve is used to obtain a brix
reading.
Daily Procedures
The following procedure should be performed
daily.
Remove the splash shield and front drip tray. Take these
parts to the sink and brush-clean them. Reinstall the
parts onto the freezer. Use a clean, sanitized towel and
wipe down the front of the machine, including the doors
and spouts.
Summary of Contents for C302
