Taylor C152, Operator'S Manual

Page: 21 / 44

USER INTERFACE
5-3
085592-M
User Interface
5
5. When the unit cycles off, place the feed tube in its
original position (mix delivery hole end down) and
install air orifice.
Figure 5-2 Feed Tube Position during Normal Operation
Important! The standby mode must not be used instead
of daily disassembly, cleaning, and sanitizing.
WASH Key
When the WASH key is pressed, the light comes on,
indicating beater motor operation. The standby or auto
mode must be canceled first to activate the wash mode.
AUTO Key
When the AUTO key is pressed, the light comes on,
indicating that the main refrigeration system has been
activated. In the auto mode, the wash or standby
functions are automatically canceled. The mix
refrigeration function is automatically locked in to
maintain the temperature of the mix in the mix hopper.
Note: An indicating light and an audible tone will sound
whenever a mode of operation has been pressed. To
cancel any function, press the key again. The light and
mode of operation will shut off.
Indicator Light—MIX LOW
Located on the front of the machine is a mix level
indicating light. When the light is flashing, it indicates that
the mix hopper has a low supply of mix and should be
refilled as soon as possible. Always maintain at least 3 in.
(76 mm) of mix in the hopper. If you neglect to add mix, a
freeze-up may occur. This will cause eventual damage to
the beater, blades, drive shaft, and freezer door.
Indicator Light—MIX OUT
When the Mix Out symbol is illuminated, the mix hopper
has almost completely exhausted and has an insufficient
supply of mix to operate the freezer. At this time, the Auto
mode is locked out and the freezer will be placed in the
Standby mode. To initiate the refrigeration system, add
mix to the mix hopper and touch the Auto symbol. The
freezer will automatically begin operation.
Reset Button
The reset button is located on the side of the C152 unit
and on the front of the C161 unit. The reset protects the
beater motor from an overload condition. If an overload
occurs, the reset mechanism will trip. To properly reset
the freezer:
1. Press the AUTO key to cancel the cycle.
2. Turn the power switch to the OFF position.
3. Wait two or three minutes and then press the reset
button firmly.
CAUTION! DO NOT use metal objects to press
the reset button. Failure to follow this instruction may
result in electrocution.
4. Turn the power switch to the ON position.
5. Press the WASH key and observe the freezer's
performance. If the beater motor is turning properly,
press the WASH key to cancel the cycle.
6. Press the AUTO key on both sides of the unit to
resume normal operation. If the freezer shuts down
again, contact a Taylor service technician.