6-2
OPERATING PROCEDURES
Models 8752, 8756, and 8757
Operating Procedures
6
2. Install the driveshaft through the rear-shell bearing in
the freezing cylinder and engage the hex end firmly
into the gearbox coupling. Make sure the driveshaft
fits into the drive coupling without binding.
Figure 6-3
WARNING!
Use extreme caution
when
handling the beater assembly.
The scraper blades are
very sharp and may cause injury.
3. Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
Figure 6-4
4. If the blades and clips are in good condition, place
the rear scraper blade over the rear holding pin on
the beater.
Note:
The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Figure 6-5
Note:
Replace scraper blades every 3 months.
5. Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin.
Figure 6-6
6. Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
7. Install the beater shoes.
11419
11529
11534
Summary of Contents for 8757
Page 14: ...3 4 SAFETY Models 8752 8756 and 8757 Safety 3 Notes...
Page 28: ...5 4 USER INTERFACE Models 8752 8756 and 8757 User Interface 5 Notes...
Page 52: ...9 2 PARTS REPLACEMENT SCHEDULE Models 8752 8756 and 8757 Parts Replacement Schedule 9 Notes...
Page 58: ...11 4 LIMITED WARRANTY ON PARTS 8752 8756 and 8757 Limited Warranty on Parts 11 Notes...
