11
800-628-5188
Rev: 10.13.21
Taylor Made
®
Manual Bimini
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004206
Fig.23
Adjustable Front Support Tubes
Eight-foot canopies require a 72-inch expanse between the
rear and front support tubes. Ten-foot canopies require a
74-inch expanse
(Fig.15)
. The baseline front measurement
for either size canopy originates from the center of the
pivot pin in the mounted primary bow assembly.
Install left and right adjustable front support tubes:
NOTE:
Adjustable front support tubes come pre-assembled
to the secondary bows.
1.
Use a tape measure and pencil to locate and mark along
the left and right fence railings 38” from the pivot pin in the
center mounting H-bracket to each left and right adjustable
front support tube
(Fig.27)
.
Fig.24
center
mounting
H-bracket
rear
34” for 8-ft
36” for 10-ft
left primary bow
assembly
left rear
support tube
fence
railing
C.
Place the two rear support tube H-brackets
(Fig.25A)
at the previously marked locations (step 1.A or B),
aligning the center of the pivot pin hole with the marked
measurement
(Fig.25)
.
D.
Secure each H-bracket to the fence railing with two
Phillips head self-drilling screws
(Fig.25B)
.
E.
Reposition the primary bow assembly towards the rear.
F.
Align each rear support tube’s mounting pivot hole over
its H-bracket’s pivot hole
(Fig.26)
.
G.
Secure the rear support tubes
(Fig.26A)
to the
H-brackets
(Fig.26B)
with the previously removed (step A)
quick-release ring pins
(Fig.26C)
.
Fig.25
A
B
marked measurement
pivot pin hole
B
A
A
B
C
Fig.26
