Page 43
TT-316 Curtis AC System Operator Manual
TT-316-07
Side Extract Battery
1. Position the vehicle as close as possible to the platform or dolly where the battery is to be
extracted.
2. Turn the start switch OFF and set the park brake.
3. Disconnect the battery cable connector.
4. Remove the battery doors.
5. Use a winch to pull the battery out or a hydraulic ram to push the battery from the opposite end.
Install
1. Position the vehicle as close as possible to the platform or dolly where the battery is stored.
2.
Confirm the start switch is OFF and the parking brake is set.
3. Use a winch to pull the battery into the vehicle or a hydraulic ram to push the battery from
the opposite end.
4. Install the battery doors making sure that both door properly engage the door interlock
switches.
Note: The vehicle will not operate unless the doors are properly installed.
5. Connect the battery cable connector.
