Taylor-Dunn SS-025-34, Service And Parts Manual

Page: 72 / 134

Chargers
Page 72
SS and MX Models, DC System
MS-534-13
REMOVE/INSTALL
There are many charger options available for this
model. The different charger may have different wiring
connections.
Disconnect the batteries and make sure that the AC
power cord has been unplugged before disconnecting
any charger wires or cords.
Some charger models have disconnects close to the
charger and some have full length wire and molded
cords. When replacing chargers with full length wires and
molded cords, DO NOT cut and splice the wires or cord.
Cutting the wires or cord will void the charger warranty
and may result in incorrect operation of the charger or
premature failure.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
TROUBLESHOOTING
Troubleshooting control system is not included in this
manual.
All electrical troubleshooting information is included in
a separate manual “Troubleshooting Electric Vehicles”.
The manual part number is M7-001-69 and was provided
on the original vehicle CD. A hard copy can be purchased
from your authorized Taylor-Dunn distributor or can be
downloaded from the Taylor-Dunn web site.
HIGH VOLTAGE.
Disconnect the batteries and make sure that the AC
power cord has been unplugged before disconnecting
any wires or removing the cover of the charger.
Failure to follow this instruction may result in serious
injury due to electric shock and/or property damage.
WARNING
Standard Single Phase AC wire Color Codes as of 2010.
Note: Older systems may use a alternate color
code.
Refer high voltage wiring repairs to a qualified technician
United States / Canada
Neutral: White
Hot: Black or Red
Ground: Green
IEC (Europe) and United Kingdom
Neutral: Blue
Hot: Brown
Ground: Green/Yellow