Taylor-Dunn SC 0-90, Operation, T Roubleshooting And Replacement Parts Manual, Page: 43 / 130

Maintenance, Service, and Repair
Steering Components
Page 9
REPLACE THE STEERING WHEEL
6. Cut the safety wire from the turn buckles and discard.
7. Remove the retaining clip and washer(s) from the
steering wheel shaft.
Note: The retaining clip goes completely around
the shaft two times. Locate the end of the
clip and lift the end of the clip out of the
groove with a small screwdriver. The clip
can then easily be removed by rotating it
around the shaft. See the illustration to the
right.
8. Loosen the turn buckles so that the steering chain
can be lifted off of the steering wheel sprocket.
9. Remove the steering wheel.
10. Install the steering wheel in reverse order.
Note: Lightly lubricate the steering wheel shaft.
11. Align the steering. Refer to section
Front End Alignment
for information regarding aligning
the steering.
12. Reconnect the main positive and negative cables at the batteries.
13. Remove the blocks from behind the wheels.
14. Release the parking brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Clip partially removed