Taylor-Dunn G-100 2018, Owner'S Manual, Page: 38 / 111

4. Press and hold the MODE button until the next segment flashes. Release the
button.
5. Repeat steps 3-4 twice to set the 10-minute and 1-minute segments. After
completing the 1-minute segment, step 4 will save the new settings and exit
the clock mode.
6. Turn the key to the OFF position.
ODOMETER MODE
The odometer records and displays the distance traveled by the vehicle.
TRIP METER MODE
The trip meter records the distance traveled by the vehicle if reset before each
trip. To reset, select the trip meter mode. Press and hold the MODE button until
the meter resets to zero. In the Rider Information Center, the trip meter display
contains a decimal point, but the odometer displays without a decimal point.
HOUR METER MODE
This mode logs the total hours the engine has been in operation.
TACHOMETER MODE
The engine RPM is displayed digitally.
TIP
Small fluctuations in the RPM from day to day may be normal because of
changes in humidity, temperature and elevation.
PROGRAMMABLE SERVICE INTERVAL
When the hours of engine operation equal the programmed service interval
setting, the wrench icon will flash for 5 seconds each time the engine is started.
When this feature is enabled, it provides a convenient reminder to perform
routine maintenance. The service interval is programmed at 50 hours at the
factory.
To change the service interval, do the following:
1. Press the MODE button until remaining service hours display.
2. Press and hold the MODE button.
3. When the service hours flash, press and release the MODE button to
advance the hours to the desired setting (including OFF). Press and hold the
MODE button to set the new service hour interval.
36
FEATURES AND CONTROLS